Minor adjustments can be made to the fit of the doors. This should be done only after the cabinet is level. There are three screws on each hinge that are used to adjust the doors up and down, left to right, and in and out. Please see the diagram below.

Horizontal by screw adjustment		In and Out by loosening the hinge-arm mounting screw		Vertical via slots in the mounting plate

It is very important that the retractable doors be pulled all the way out before closing the doors. Pull each door straight out from the case until it passes the "speed bump", and then close the door. Failure to extend the doors fully before closing may result in damage to the hinge or to the door.

Retractable doors may be adjusted in the same manner as other doors. It is very important to make sure the case is level, because the retractable doors will not operate properly if the case is uneven.

Our drawers are equipped with tandem drawer slides which fit under the drawer. The slides consist of two runners that ride just under the drawer bottom, and clip into the locking devices attached to the bottom front of the drawer.

To remove the drawer, reach under the drawer and squeeze the two locking devices. This will release the runners and the drawer can be pulled out.

To replace the drawer and lock it in, pull each runner forward until it clicks into the locking device. The drawer will not run smoothly if it is not locked in.

The locking device has an adjustment level to raise or lower the height of the drawer. Press up on the lever, and push forward or back to adjust the height of the drawer.

Drawer Removal To remove the drawer, reach under the drawer and squeeze the two locking devices. This will release the runners, and the drawer can be pulled out.		Drawer Installation To replace the drawer and lock it in, pull each runner forward until it clicks into the locking device. The drawer will not run smoothly if it is not locked in.		Height Adjustment The locking device has an adjustment lever to raise or lower the height of the drawer. Press up on the lever, and push forward or back to adjust the height of the drawer.